Glycol-Water Solution Properties & Flow Derating
Evaluate inhibited Ethylene Glycol and Propylene Glycol (0%–60% per ASHRAE Fundamentals Ch. 31 mass-percent tables) for freeze & burst protection, specific heat, specific gravity, kinematic viscosity, GPM flow correction factor, and Darcy-Weisbach head-loss multiplier.
Solution & Reference Pipe Inputs Propylene 35%
Properties & Derating Multipliers Turbulent
Evaluating glycol mixture...
Concentration Comparison Table (0%–60% at Current Temp)
| Glycol % | Freeze (°F) | Burst (°F) | SG | cₚ (BTU/lb·°F) | Viscosity (cP) | Flow Factor | Head Mult. |
|---|
Worked Equations & Live Substitution
Maintains identical BTU/hr (kW) heat transfer at the same loop ΔT.
Computed directly via Darcy-Weisbach Reynolds shift and flow-rate increase.
ASHRAE Glycol Selection & Commissioning Guidance
Concentration & Corrosion Control
- Minimum 25%–30% Rule: Never run <25% inhibited glycol; insufficient inhibitor concentration accelerates steel and aluminum corrosion.
- Avoid >55% Glycol: Higher concentrations degrade heat transfer, spike cold-start pump amps, and can cause laminar flow in coils.
Equipment & Pipe Compatibility
- No Galvanized Pipe: Glycol strips zinc from galvanized steel, forming sludge that clogs heat exchangers and control valves.
- Automatic Make-Up Warning: Use a glycol feeder rather than raw city water make-up so leaks don't silently dilute freeze protection.
Frequently Asked Questions
What is the difference between freeze point and burst protection point for glycol?
The freeze point is the temperature at which the first ice crystals begin to form (slush), whereas the burst point is the much lower temperature at which the slush expands rigidly enough to rupture copper or steel pipes. Typically 30% to 35% glycol provides burst protection down to −15°F to −40°F even if flow stops.
When should I choose Propylene Glycol instead of Ethylene Glycol?
Propylene glycol is non-toxic (GRAS) and required by plumbing codes whenever a heat exchanger is near potable domestic water or in food-processing/healthcare facilities. Ethylene glycol has lower viscosity and superior heat transfer at cold temperatures, making it preferred for industrial snow-melt and large chilled-water loops without potable cross-connection.
Why should glycol concentration stay between 25% and 50% by volume?
Below 25% glycol, corrosion inhibitors can become too diluted to protect steel and copper, risking biological growth and pitting. Above 50% to 60%, viscosity rises exponentially at cold temperatures while specific heat drops sharply, and pure 100% glycol actually has a higher freeze point than a 60% water mixture.
Why does pump head loss increase so dramatically with cold glycol?
At 32°F (0°C), 40% propylene glycol has nearly 5 times the viscosity of pure water, reducing Reynolds number into transitional or laminar flow where friction factor spikes. Combined with the higher GPM needed to offset lower specific heat, total loop head loss can increase by 40% to 80%.