FlowBench / Engineering Disclaimer

Engineering Disclaimer

Decision-Support Tool Only — Verify with a Licensed PE and Local Codes

All calculators, charts, reference tables, and engineering notes provided on FlowBench are intended solely as preliminary design and educational decision-support aids. They do not constitute stamped engineering design, professional advice, or code-compliance certification.

1. Professional Verification Required

Before specifying equipment, issuing construction drawings, or modifying pressurized hydronic, steam, fire-protection, or domestic plumbing systems, all calculated outputs must be independently checked and approved by a licensed Professional Engineer (PE) or qualified authority having jurisdiction (AHJ).

2. Codes, Standards & Manufacturer Data

Pipe wall tolerances, internal roughness values, fouling allowances, glycol inhibitor formulations, pump NPSHr curves, valve flow coefficients (Cv / Kv), and safety relief settings vary by manufacturer, fluid age, and local amendments to the International Plumbing Code (IPC), Uniform Plumbing Code (UPC), International Mechanical Code (IMC), ASHRAE standards, and ASME Boiler and Pressure Vessel Code. Always consult certified manufacturer submittals and applicable local regulations.

3. Idealized Model Assumptions

  • Steady-state, incompressible single-phase liquid flow is assumed unless otherwise noted.
  • Transient water hammer (surge pressures), two-phase flashing, dissolved gas separation, and piping structural/seismic supports are outside the scope of basic head-loss calculators.
  • Pipe aging, scale buildup, biological fouling, and corrosion can significantly increase friction losses beyond clean-pipe roughness values over a system's service life.

4. Limitation of Liability

FlowBench and its contributors make no warranties regarding the completeness, accuracy, or fitness for a particular engineering application of any output generated by this website, and assume no liability for property damage, system failure, personal injury, or financial loss arising from reliance on these tools. See our Terms of Use for full terms, or Contact Us with technical questions.