FlowBench / About & Methodology

About FlowBench & Engineering Methodology

FlowBench is an independent engineering calculation workbench built for mechanical engineers, HVAC hydronic designers, plumbing engineers, commissioning technicians, and facility operators. Every tool runs transparently in your browser with synchronized US Imperial and SI Metric unit systems, shareable URL state, and verified physical property tables.

Our Mission

Field checks and preliminary system sizing shouldn't require opaque spreadsheets or guessing nominal pipe internal diameters. FlowBench pairs clean, zero-reload interactive workbenches with published engineering correlations so practitioners can inspect intermediate values—Reynolds numbers, friction factors, fluid viscosity, and velocity limits—side by side.

Core Physics & Calculation Methodology

  • Pipe Friction Solvers: Full-range Darcy-Weisbach head loss using the Hagen-Poiseuille relation for laminar flow (Re ≤ 2,300) and either iterative Colebrook-White (converged to 10−10 tolerance) or explicit Swamee-Jain friction factors for transitional and turbulent regimes. Empirical Hazen-Williams calculations are provided alongside for fire protection and municipal water mains.
  • Exact Schedule & Tube Dimensions: Internal diameters and absolute roughness (ε) are tabulated from published standards rather than rounded nominal sizes, covering Copper Types K, L, and M, PEX-A/B (CTS SDR 9), Schedule 40 & 80 Carbon Steel, CPVC Schedule 40 & 80, and HDPE DR 11.
  • Temperature-Dependent Water & Glycol Properties: Water density, dynamic/kinematic viscosity, specific heat, and saturation vapor pressure are computed continuously from 32°F to 212°F (0°C to 100°C). Ethylene and propylene glycol solutions (0%–60% by volume) use bilinear interpolation across ASHRAE Fundamentals thermophysical tables to capture low-temperature viscosity spikes and heat-capacity derating.

Standards Alignment

Domain Referenced Standards & Publications
Hydronic Heating, Cooling & Glycol ASHRAE Handbook — Fundamentals & HVAC Systems and Equipment; ASHRAE Standard 90.1
Piping Dimensions & Pressure Vessels ASME B36.10M (Steel Pipe), ASTM B88 (Copper), ASTM F876 (PEX), ASTM F441 (CPVC), ASTM D3035 (HDPE), ASME BPVC Sec. IV
Pumps, NPSHa & Minor Losses Hydraulic Institute (HI 9.6.1 / 14.3), Crane Technical Paper 410 (TP-410), ISA-75.01, ISO 5167
Plumbing & Domestic Water Demand International Plumbing Code (IPC), Uniform Plumbing Code (UPC), AWWA / NFPA Hazen-Williams C-Factors
Questions or Standards Feedback?

If you notice a discrepancy in a correlation or want to suggest an additional reference table, reach us at Contact FlowBench or review our Engineering Disclaimer.